Gateway Computer Drive User Manual download pdf (Page 27)

Installing a drive

www.gateway.com

Installing a drive

This section tells you how to install the drive and how to attach the cables.

To install a drive:

1 Slide the drive into the bay and secure the drive in the drive bay by

following the instructions in your computer user’s guide.

2 If your drive is a CD or DVD drive, connect the audio cable.

3 Connect any unused power cable to the power supply connector on the

drive. Use a large power connector for CD, DVD, flash memory, Zip, and

tape drives, and use a smaller power connector for diskette drives.

If you do not have enough power connectors, disconnect a power cable

from one of your drives and place the Y-adapter power cable that came

with the new drive on the end of the existing power cable to make two

power connectors.

Important If you are adding a recordable CD or DVD drive to your

computer and the audio cable is attached to your other CD

or DVD drive, you can remove the audio cable from your

other drive and attach it to your new drive.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

No comments

Gateway Computer Drive User Manual Page 27