Gateway MicroGate MG1-1000 User Manual

MicroGate™ Online Kitchen™ Gateway User GuideMG1-1000January 2005Part Number: 4911000-010Revision Number: A3MicroGate™ User Manual

Table 7 - J7 RS485 Channel #2 Pin Number Name Description Type 2 RS485_RX+ Non-Inverting Receiver Input (Full Duplex Mode) Input 4 RS485_RX- Inverti

Ethernet (RJ45) Cable Specifications and Pin Assignments Figure 3 Table 8 - Cable Specification Cable Type Max. Length Connector 10BASE-T Cat. 3,

IV. Installation and Configuration System Requirements You must meet the following requirements to install and configure the MicroGate™: • Static IP

Basic Network Configuration Procedure 1. Start the Discovery Utility by selecting Start > Programs > Raptor Web Software > ECSDiscovery – Th

Figure 6 4. Once the row corresponding to the unit to be configured is highlighted, click on Edit Unit (see Figure 6, note #1) to bring up the Unit

5. Change the IP Address, Subnet Mask, and Gateway Address as needed and then click on Update (see Figure 7, note #1) to send configuration to the un

V. Part Number Selection See Figure 8 for configuration options and suggestions. For custom configurations please consult E-Control Systems. Function

VI. Limited Warranties E-Control Systems' Limited Warranty Statement Limited Warranty Statement: E-Control Systems ("ECS") warrants it

ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME COUNTRIES DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES OR THE LIMITATION OF INCIDENTAL OR CONSEQU

TABLE OF CONTENTS I. INTRODUCTION...

I. Introduction • Everything you need for full NAFEM protocol compliance • Translates and organizes your legacy equipment's data into the NAFEM

Total Online Kitchen™ Solution Package Coupled with E-Control Systems' enterprise Raptor Web Software™, equipment manufacturers, systems integrat

II. Features and Specifications Architecture CPU: Advanced High Performance Motorola 32-bit embedded PowerPC™ Network Processor with 66 MI

With Modem: Input Current (25 MHz Clock): 490mA max Input Current (50 MHz Clock): 610mA max Environmental Operating: 0 C to 70 C (32 F to 158 F

III. Hardware Description The MicroGate™ is meant to be connected between a local network/internet (using the LAN Port) and the equipment(s) (using an

LED Indicators Table 2 - LED Indicators Designator Name Condition Status On The Ethernet Port has established a valid network connection DS1 Link (

RS232 Serial Port Pin Assignment Table 5 - J4 (RS232 Channel #1) or J9 (Channel #2) Pin Number Name Description Type 1 CD Carrier Detect Input 2