Gateway 9315 User Manual download pdf (Page 84)

www.gateway.com

9 Install the new processor into the CPU socket, then press the processor locking lever

down until it lays flat against the CPU socket.

10 Place the heat sink over the processor, lining up the four captive screws with the four

posts surrounding the processor.

11 Loosely screw in the captive screws on the corners of the heat sink, gently tightening

diagonal screws (screw in one screw, then the screw located diagonally to the first

screw). Do not fully tighten one screw before tightening another.

12 Gradually and equally tighten each captive screw until each is firmly tightened. Do

not over-tighten the screws.

13 Follow the instructions in “Installing the processor air duct” on page 42.

14 Follow the instructions in “Closing the server case” on page 39.

Important If you install two processors onto the system board, the processors

must be the same speeds, revision, core voltage, and bus speed.

Caution The heat sink has Thermal Interface Material (TIM) located on the

bottom of it. Use caution when you unpack the heat sink so you do

not damage the TIM.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 167 168

No comments

Gateway 9315 User Manual Page 84