Gateway E-9520T User Manual download pdf (Page 49)

www.gateway.com

10 Place the heatsink on the installed processor, aligning it so that it fits squarely in the heatsink

socket.

11 Push down the heatsink retaining levers and lock them under the retaining hooks on the

heatsink socket.

12 Follow the instructions in “Closing the server case” on page 26.

Replacing a power supply module and power

board

Your server uses as many as two 725 W hot-swappable power supply modules (optional). If your

server has both power supply modules installed, the modules act as redundant, hot-swappable

power supplies. If one of the two power supplies fails, the other power supply supports the server

while you replace the failed power supply. You do not need to turn off the server or disconnect

peripheral devices to replace a failed redundant power supply.

If your server is only equipped with a single power supply (standard), the server must be turned

off and the AC power cord removed before replacing it.

To replace a power supply module:

1 If your server is equipped with more than one power supply module, determine which

power supply module has failed (the LED on the power supply will be orange).

2 If your server has only one power supply module installed, make sure that you turn off the

server, then unplug the power cord before continuing.

- OR -

If your server has two power supply modules installed, you do not need to turn off the

power to the server before continuing.

3 Press down on the retaining clip (1) on the power supply to release the power supply module

(2) from the chassis.

Caution

The heatsink has Thermal Interface Material (TIM) located on the bottom of

it. Use caution when you unpack the heatsink so you do not damage the TIM. If you

are reusing the original heatsink, make sure that the TIM on the bottom of the

heatsink is not damaged. If the TIM is damaged, you should apply new TIM to the

bottom of the heatsink.

Caution

The power supplies in this server contain no user-serviceable parts. Only a qualified

computer technician should service the power supplies.

Your server comes with 3-wire ACpower cords fitted with the correct plug style for your

region. If this plug does not match the connector on your surge protector, UPS, or wall outlet,

do not attempt to modify the plug in any way. Use a surge protector, UPS, or wall outlet

that is appropriate for the supplied AC power cords.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 113 114

No comments

Gateway E-9520T User Manual Page 49