Gateway XHD3000 User Manual download pdf (Page 47)

www.gateway.com

To use headphones:

• Plug headphones into either of the speaker bar’s

headphone jacks. The speaker bar’s volume is muted,

and sound is played through the connected headphones.

You can connect headphones to both headphone jacks,

and sound plays out of both sets of headphones.

Power management

Whenever no video signal is detected by your monitor, it enters

Standby mode, a mode that uses very little power. When in

Standby mode, the power button turns orange. Turning off

your computer stops its video signal to the monitor, so if your

computer is the only video source connected, your monitor

enters Standby.

If the monitor does not enter Standby, and instead displays a

prompt for the product tour, you should disable the product

tour.

To disable the product tour and enable Standby mode:

1 Touch (Menu), (Main Menu), then touch

(Advanced).

2 Touch one of the (Adjust) buttons to select

Integrated Product Tour, then press (Select) to

disable the tour.

Energy declaration

When connected to a computer that supports the VESA Display

Power Management Signaling (DPMS) Protocol, the monitor

can conserve significant energy by reducing power

consumption during periods of non-use. When your computer

goes into the energy saving mode, the monitor will then enter

the Active Off mode (sleep). In the Active Off mode the Power

LED will still show orange.

Use these conventions and the power can be reduced to the

following levels:

VESA State LED Indicator Power Consumption

On Blue ≤168 W

Standby Amber ≤19 W

Off Purple ≤19 W

8512322_XHD3000 Usr Gde.book Page 41 Friday, August 10, 2007 12:33 PM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 91 92

No comments

Gateway XHD3000 User Manual Page 47