Gateway E-3200 User Manual download pdf (Page 41)

32 Maintaining and Troubleshooting Your E-3200 System

Replacing the hard drive

The hard drive is secured to a mounting plate that snaps out of and into the

chassis.

Turn off the system and disconnect the power cord.

Open the case, observing the “Static Electricity Precautions” on

page 2.

Locate the 3.5-inch hard drive and mounting plate ring.

Lift the ring slightly and then pull it towards the center of the drive

until the spring latch releases. Lift the drive out of the chassis.

Remove the mounting plate from the old drive by lifting and sliding

one tab at a time until they unlock. Lift the mounting plate off the

drive.

Position the new drive upside down in the mounting plate and snap it

into place.

Place the drive back into the drive bay.

Connect the power and data cables to the back of the drive. (See drive

documentation for proper drive jumper settings and cable orientation.)

Close the case, as described in Chapter 1.

10.

Reconnect the power cord and turn on the system.

To replace the hard drive

Important!

Make sure the option ROMs

on your add-in cards

conform to the Phoenix

POST Memory Manager

Specification, Version 1.01

and BIOS Boot

Specification, Version 1.01.

For additional information,

refer to the following websit:

http://www.phoenix.com.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 89 90

No comments

Gateway E-3200 User Manual Page 41