Gateway ALR 7200 User Manual download pdf (Page 47)

Installing Components 35

Installing memory and hardware

Installing memory

The system board supports up to 1 GB of RAM in ECC SDRAM DIMMs.

The system board is configured with 4 DIMM banks. You can fill Bank 0,

Bank 1, Bank 2, or Bank 3 or a combination of banks with DIMMs. No

jumper settings are required for the memory size or type because this

information is automatically detected by the BIOS.

Refer to the DIMM configuration chart later in this section for valid

memory configurations. You may select any combination that provides the

total RAM required by your system and applications.

Turn off the system and disconnect the power cord.

Open the case (“Opening the system” on page 3), observing the static

electricity precautions in “Static electricity precautions” on page 2.

Pull open the socket clamps on each side of the DIMM socket.

Figure 15: Opening the DIMM Socket Clamps

Insert the DIMM into the socket and align the two notches in the

DIMM with the two notches in the DIMM socket.

To install DIMMs

4077.boo Page 35 Thursday, January 21, 1999 9:48 AM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 133 134

No comments

Gateway ALR 7200 User Manual Page 47