Gateway ALR 8300 User Manual Page 62
- Page / 128
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
50 Maintaining and Troubleshooting the Gateway ALR 8300 Server
Installing software and drivers
The procedure for installing software and drivers is usually specific to the
operating system you will run on the server. Here are some tips.
Installing the USB driver
To use a USB device, you must install the USB driver in a computer
running Windows 95. A 3.5-inch disk labeled “Integrated Controller UATA
files for Win 95” was shipped with your computer. You must use this disk
to install the USB driver.
1.
Start the computer.
2.
Put the 3.5-inch disk labeled “Integrated Controller UATA files for
Win 95” into the disk drive.
3.
Open the
Readme.1st
file and follow the instructions on screen.
After you have installed the USB driver, install the USB device by attaching
it to a USB port on the rear panel. Check the device documentation for
additional information to see if you must install software for the device.
Installing video drivers
The integrated video controller on the system board uses standard drivers
provided with the system utilities diskettes. For those running Windows NT
in particular, use the driver provided on the utilities diskettes (Cirrus Logic
Windows NT 4.0 diskette) not those provided on the Windows NT
installation CD-ROM. The drivers provided on the Windows NT CD-ROM
may not function correctly.
Video driver installation varies depending on the operating system that you
run on the server. Refer to the documentation for the operating system for
specific instructions.
To Install the USB Driver
4081TL.book Page 50 Tuesday, December 22, 1998 1:27 PM
- Maintaining 1
- Troubleshooting 1
- ALR 8300 Server 1
- All Rights Reserved 2
- Trademark Acknowledgments 2
- Contents 3
- Contents iii 5
- Safety instructions 9
- The Gateway Support Center 11
- Chapter 1: 13
- System Access 13
- Caution! 14
- Warning! 14
- Opening the system 15
- Removing the bezel 17
- Figure 3: Removing the Bezel 18
- Closing the system 19
- Reinstalling the side panel 21
- Chapter 2: 23
- Components 23
- System board 24
- Components 13 25
- Chassis fans (A, F, S) 26
- Power connectors 26
- Front panel connectors 27
- Diskette drive connector (I) 29
- SCSI connectors (X, Y) 29
- System jumpers 30
- Server management connectors 31
- Battery (AA) 32
- Expansion slots 32
- I/O connectors 33
- Processor subsystem 34
- The RAID backplane 35
- Chapter 3: 37
- Installing 37
- Replacing the processor 38
- Installing Components 27 39
- Important! 39
- Installing a second processor 41
- Installing Components 31 43
- Setting system board jumpers 44
- Clear CMOS jumper 45
- SHM mode jumper 46
- Installing memory 47
- To Remove DIMMs 48
- Adding and replacing drives 49
- Installing Components 39 51
- Installing Components 41 53
- Replacing a RAID drive 55
- SCSI cable kit installation 57
- Adding an expansion card 58
- Installing Components 47 59
- Replacing the lithium battery 60
- Installing Components 49 61
- Installing the USB driver 62
- Installing video drivers 62
- NetWare drivers 63
- Chapter 4: 65
- BIOS Setup 65
- About the BIOS Setup Utility 66
- Using the BIOS Setup Utility 66
- Main menu screen 67
- Hard disk drive setup screen 69
- Advanced menu screen 71
- Resource configuration screen 73
- Memory reservation screen 74
- Memory Reservation 74
- Available 74
- Reserved 74
- IRQ reservation screen 75
- IRQ Reservation 75
- Keyboard features screen 77
- Cache memory screen 78
- Security menu screen 79
- Boot menu screen 81
- Exit menu screen 82
- BIOS Setup 71 83
- Updating the BIOS 84
- BIOS Setup 73 85
- Chapter 5: 87
- Introduction 88
- Computer virus notice 88
- Troubleshooting checklist 89
- Verifying the configuration 90
- Troubleshooting guidelines 90
- CD-ROM problems 91
- Hard disk problems 92
- Memory/Processor problems 93
- Peripheral/Adapter problems 94
- Printer problems 95
- System problems 97
- Video problems 98
- The video is distorted 99
- Error messages 100
- Troubleshooting 89 101
- Appendix A: 103
- Reference Data 103
- Acronyms and abbreviations 104
- Terms and definitions 105
- Reference Data 95 107
- Specifications 108
- Memory Map 109
- IRQ Usage 111
- DMA Usage 112
- DIMM Configurations 113
- FCC notice 115
- Industry Canada notice 115
- CE notice 116
- VCCI notice 116
- Australia/New Zealand notice 117
- Numerics 119
- Index 109 121
- Index 111 123
- Index 113 125
- Index 115 127
Related products and manuals for Servers Gateway ALR 8300
Servers Gateway E-9425R User Manual
(118 pages)
(118 pages)
Servers Gateway ALR 7300 User Manual
(138 pages)
(138 pages)
Servers Gateway 6400 User Manual
(148 pages)
(148 pages)
Servers Gateway ALR 9200 User Manual
(226 pages)
(226 pages)
Servers Gateway 9415 User Manual
(188 pages)
(188 pages)
Servers Gateway 960 User Manual
(157 pages)
(157 pages)
Servers Gateway GT150 F1 User Manual
(16 pages)
(16 pages)
Servers Gateway 955 User Manual
(144 pages)
(144 pages)
Servers Gateway E-9520T User Manual
(114 pages)
(114 pages)
Servers Gateway TT.R5900.108 Datasheet
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 0.340 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals