Gateway E-4400 User Manual download pdf (Page 40)

Removing the system board

Locate the release lever at the outside center edge of the system board

and lift the lever upward slightly. Pull it outward approximately eighty

degrees from the edge of the system board to disengage the edge

connector on the system board from the riser card and move the board

slightly out of the chassis.

7 Grasp the edge of the system board and carefully slide it out of the chassis.

8 If the system board is being replaced, remove the rails from the bottom

of the board and place the board in a static-free container.

Caution Be careful when handling the system board. The edges of

the I/O panel are sharp and can cause injury if not handled

with caution.

I/O panel

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 117 118

No comments

Gateway E-4400 User Manual Page 40