Gateway E-4400 User Manual download pdf (Page 94)

Error messages

Diskette drive reset failed. Enter the BIOS Setup utility, then verify the

diskette drive parameters.

Check the diskette drive cables. Make sure

Pin 1 on the cable aligns with Pin 1 on the

connector.

Diskette read failed - press

F1 to retry boot.

Make sure the boot disk contains the

Command.com file. Use the configuration

utility (if applicable) to verify your drive or

controller configuration. Press F1 to try to

restart the computer.

Gate A20 failure. You may have an XT keyboard connected to

an AT system or vice versa. Make sure the

keyboard is configured to work with the

appropriate system. Some keyboards have a

switch to select either AT or XT.

Hard disk controller failure. Make sure the hard drive cable is properly

connected.

Open the BIOS Setup utility program, then

verify that the correct drive type is selected.

Hard disk controller failure -

press

to try reboot.

The drive controller may be defective. Press F1

to try to restart the computer.

Try running Fdisk and DOS Format. For more

information, refer to your DOS documentation.

Insert bootable media

device.

See “The IDE drive is not recognized by the

system” on page 75 for possible solution.

See “The SCSI drive is not recognized by the

system” on page 75 possible solution.

Backup your files as soon as possible.

Insufficient disk space. Check the free space on the disk volume. If the

volume is full or almost full, remove

unnecessary files.

Invalid configuration

information…

Enter the BIOS Setup utility, then verify the

parameter values.

Error Message Solutions

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 117 118

Comments to this Manuals

No comments

Gateway E-4400 User Manual Page 94

Comments to this Manuals

Related products and manuals for Computers Gateway E-4400