Gateway E-9425R User Manual download pdf (Page 54)

CHAPTER 4: Installing Components

7 Align the new power distribution board with the stand-off and locking tabs on the chassis,

then place it on the stand-offs and slide it toward the side of the chassis until the tab clicks

into place.

8 Replace the screw you previously removed.

9 Reconnect the power cables. See “System board” on page 4 for the location of the

connectors on the system board.

10 Reinstall the power supply modules by following the instructions in “Replacing a power

supply module” on page 46.

11 Follow the instructions in “Closing the server case” on page 30.

Replacing the power cage

To replace the power cage:

1 Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure

that you turn off the server, then unplug the power cord(s) and all other cables connected

to the server.

2 Follow the instructions in “Opening the server case” on page 29.

3 Remove the power supply modules by following the instructions in “Replacing a power

supply module” on page 46.

4 Remove the power distribution board by following the instructions in “Replacing the

hot-swap backplanes” on page 49.

5 Loosen the screws (3) holding the power cage in the chassis.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 117 118

No comments

Gateway E-9425R User Manual Page 54