Gateway E-9425R User Manual download pdf (Page 60)

CHAPTER 4: Installing Components

Replacing the control panel

To replace the control panel:

1 Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure

that you turn off the server, then unplug the power cord(s) and all other cables connected

to the server.

2 Follow the instructions in “Opening the server case” on page 29.

3 Unlock the bezel (if necessary) and remove it by pulling it straight out from the front of

the chassis.

4 Disconnect the cables from the control panel.

5 Push the retaining clips (1) to the open position, then slide the control panel (2) back from

the front of the server to disengage it from the locking tabs and remove it.

6 Holding the new control panel by the edges, align it with the locking tabs, then place it

on the tabs and slide it toward the front of the chassis.

7 Push the retaining tabs to the closed position to hold the control panel in place in the

chassis.

8 Connect the cables that you previously removed.

9 Follow the instructions in “Closing the server case” on page 30.

10 Replace the bezel by snapping it into place on the front of the server.

Replacing the system board

To replace the system board:

1 Follow the instructions in “Preventing static electricity discharge” on page 28. Make sure

that you turn off the server, then unplug the power cord(s) and all other cables connected

to the server.

2 Follow the instructions in “Opening the server case” on page 29.

3 Remove the system fans and fan cage by following the instructions in “Replacing system

fans” on page 41.

4 Remove the PCI riser assembly by following the instructions in “Installing and removing

PCI expansion cards” on page 39.

5 Remove the memory modules by following the instructions in “Installing memory” on

page 36.

Caution

Your server must be operated with a control panel module in place.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 117 118

No comments

Gateway E-9425R User Manual Page 60